Configuration Options

Interface Configuration Software

Use the interface configuration software on a PC to configure the product.

Communication happens via the WAGO USB Service Cable (Item Number 750-923) or WAGO Bluetooth® Adapter (Item Number 750-921).

For additional information about the interface configuration software, visit www.wago.com.

Interface Configuration App

With the JUMPFLEX® ToGo interface configuration app, you can use a smartphone or table to configure the parameters.

The service interface is used for communication between the smartphone/tablet and the product via the WAGO Bluetooth® Adapter (Item Number 750-921).

Configuration Display

Using the configuration display (Item Number 2857-900), you can configure the parameters on the product directly.

Simply snap the configuration display on to the service interface for this.

The following menu items are available for configuring the product:

Product Menu Configuration Display

Menu Item

Subitems

Process Values

Input: Status, Active Power, Apparent Power, Reactive Power, Voltage, Current, Phase Angle, Cos Phi; Frequency
Output: Analog Output; Digital Output; Relay

Input

Signal; Voltage; Current; Filter

Output

Signal; Start Value; End Value; Lower Limit Violation; Upper Limit Violation; Substitute Values

Digital output

Inactive; US-Switching; GND-Switching; Threshold Value Switch; Frequency Generator; S0 Interface

Relay

Inactive; Energizing; Deenergizing; Threshold Value Switch

Simulation

Input or output value

General

Password; Factory default setting

Device Information

Item Number; Product Name; HW Id; SW Id

Note

Observe the documentation for the configuration display!

For information on operating and configuring the configuration display (Item Number 2857-900), please refer to the configuration display documentation (e.g., via www.wago.com/2857-900).