Intended Use
e!COCKPIT is an integrated development environment with seamless data retention for all automation tasks:
- Hardware configuration and parameterization
- Programming with integrated e!RUNTIME
- Visualization (operation and monitoring)
- Diagnostics for targeted development and commissioning
Software operation is only permitted if the system requirements and license conditions are met.
Improper Use
Improper use of the products is not permitted. Specifically, improper use occurs in the following cases:
- Non-observance of the intended use
- Use of the products in areas with special risk that require flawless continuous operation and in which failure or operation of the software can result in an imminent risk to life, limb or health or cause serious damage to property or the environment (such as the operation of nuclear power plants, weapon systems , aircraft and motor vehicles)
Warranty and Liability
The terms set forth in the General Business & Contract Conditions for Delivery and Service of WAGO GmbH & Co. KG and the terms for software products and products with integrated software stated in the WAGO Software License Contract – both available at www.wago.com – shall apply. In particular, the warranty is void if:
- The products are used improperly.
- The deficiency (hardware and software configurations) is due to special instructions.
- Modifications to the hardware or software have been made by the user or third parties that are not described in this documentation and that has contributed to the fault.
Individual agreements always have priority.
Obligations of Installers/Operators
The installers and operators bear responsibility for the safety of an installation or a system assembled with the products. The installer/operator is responsible for proper installation and safety of the system. All laws, standards, guidelines, local regulations and accepted technology standards and practices applicable at the time of installation, and the instructions in the the products’ Instructions for Use, must be complied with. In addition, the Installation regulations specified by Approvals must be observed. In the event of non-compliance, the products may not be operated within the scope of the approval.