Intended Use
WAGO Solution Builder is a central development environment for tasks in building automation. This software enables contractors to organize all of their projects in one central database and to process these in parallel. The following tasks can be performed with the software:
- Create customer projects.
- Manage customer projects.
- Configure customer projects.
- Transfer customer projects to WAGO controllers.
- Document customer projects.
Software operation is only permitted if the system requirements and license conditions are met.
Improper Use
Improper use of the software is prohibited.
Improper use occurs in particular in the following cases:
- Non-observance of the intended use
- Implementation of a Known Misuse
- Use of the software in areas with special risk that require continuous fault-free operation and in which failure of or operation of the software can result in an imminent risk to life, limb or health or cause serious damage to property or the environment (such as the operation of nuclear power plants, weapons systems, aircraft and motor vehicles)
Warranty and Liability
The provisions of the latest WAGO General Terms and Conditions of Deliveries and Services (GTC) apply as well as the Software License Terms for Standard Software (SW-License) applicable to software products und software embedded in WAGO hardware products, both available at: ü www.wago.com.
In particular, the warranty is void when:
- The products are used improperly.
- The defect is based on (customer-)specific specifications (hardware and software configurations).
- Modifications of the hardware or software by the user or third parties were made that are not described in this documentation and are at least responsible for the occurrence of the defect.
Individual agreements always take precedence.
Obligations of the installer/operator
Installers and operators bear responsibility for the safety of an installation or a system assembled with the product.
The installer/operator is responsible for the proper installation and the safety of the system. It must comply with the laws, standards, guidelines, local regulations, the state and the rules of technology applicable at the time of installation and must observe the guidelines and instructions described in the operating instructions. The installation requirements of the approvals must also be met.
In the event of non-compliance, operation of product within the scope of the approval is not permitted.